28 février 2008
FT-950 Specifications
FT-950 Specifications
| GENERAL | |
RX Frequency Range: |
30 kHz to 56 MHz |
TX Frequency Ranges: |
160 to 6 m (Amateur bands only) |
Frequency Stability: |
±0.5 ppm (after 1 min. @ 25 °C) |
Operating Temperature Range: |
14 ° - 122° F (-10 °C ~ +50 °C) |
Emission Modes: |
LSB, USB, CW, F3E FM, F1B RTTY, F1D Packet, F2D Packet |
Frequency Steps: |
1/10 Hz for SSB/CW/AM |
0 |
100 Hz for FM |
Antenna Impedance: |
50 ohms balanced, 16.7 to 150 Ohms, unbalanced (Tuner ON, TX only) |
Power Consumption: |
13 VDC |
RX (no signal) |
2.0A |
RX (signal) |
2.5A |
TX (100 W) |
22 A |
Supply Voltage: |
13.8 VDC |
Dimensions (WHD): |
14.4 x 4.5 x 12.4 inches |
Weight (approx.): |
28.7 lbs. |
0 | |
TRANSMITTER | |
Power Output: |
Adjustable 5 to 100 watts (2-25 watts AM carrier), |
0 |
50% @ 100 watts (FM & RTTY, 3-minute TX) |
Modulation Types: |
J3E (SSB) Balanced, |
|
A3E (AM) Low-level (early stage), |
|
F3E (FM) Variable reactance, |
Maximum FM Deviation: |
±5.0 / ±2.5 kHz |
Harmonic Radiation: |
Better than -60 dB (Typical) |
SSB Carrier Suppression: |
At least 60 dB below peak output |
Undesired Sideband Suppression: |
At least 60 dB below peak output |
Audio Response (SSB): |
Not more than -6 dB from 300 to 2700 Hz |
3rd-order IMD: |
- 31 dB 14 MHz @ 100 watts PEP |
Microphone Impedance: |
600 Ohms (200 to 10k ohms) |
| 0 | |
| RECEIVER | |
Circuit Type: |
Triple-conversion superheterodyne (VFO-A) |
Intermediate Frequencies: |
0 |
VFO A: |
69.450 MHz/450 kHz/30 kHz [24kHz for AM/FM] |
| Sensitivity: | |||
Modes |
0.5 - 1.8 MHz | 1.8 - 30 MHz | 50 - 54 MHz |
SSB (2.4 kHz) |
2 uV | 0.2 uV | 0.125 uV |
AM (6 kHz) |
6 uV | 2 uV | 1 uV |
FM |
- | 0.5 uV (28-30 MHz) | .35 uV |
| (with RF2 amp on) | |||
| Selectivity (-6/-60 dB): | ||
| Modes | Min. -6 dB BW | Max. -60 dB |
| SSB | 2.4 kHz | 3.6 kHz |
| AM | 6 kHz | 15 kHz |
| CW/RTTY/Packet | 500 Hz | 750 Hz |
| FM | 15 kHz | 25 kHz |
IF Rejection (1.8 ~ 30 MHz): |
|
Image Rejection (1.8 ~ 30 MHz): |
70 dB or better (160-10m) |
Maximum Audio Output: |
2.5 W into 4 Ohms with <10 % THD |
Audio Output Impedance: |
4 to 8 Ohms |
Specifications are subject to change, in the interest of technical improvement, without notice or obligation. | |
Click here to view the actual FT-950 rear panel.
